As we all know, sprinklers are very common in our lives and are particularly important in environmental construction. Let's introduce how to use sprinklers correctly today. The first is the precautions when watering the car. When water is sucked in, the inlet pipe system must be kept vacuumed and sealed so that water can be drawn into the tank. In addition, when the hose of the inlet pipe system is worn out or damaged, it cannot be used. When the pipe is cracked or inflated, it cannot be used. In these cases, air leakage will occur and the water will not be sucked. When absorbing water, make sure that the end of the suction tube near the water source is completely submerged in water and that the distance between the end and the horizontal surface is always greater than 3cm. Sometimes there is a situation where there is no water source in the suburbs away from the faucet. In this case, the sprinkler needs to use river ditches and ponds as a source of water. In order to prevent the water pump from inhaling large stones or sediment and floating debris, water can be absorbed. The end of the pipe near the water source should be equipped with a filter device. When the water is suctioned, the filter device must not be removed. Otherwise it will cause siltation and cannot enter the water. The service life of the suction pipe system will be shortened over time. If the water source encounters a shallow water source, it is necessary to dig the water absorption point a little deeper and then precipitate the water to a more clarified state to ensure that it does not contain impurities or air. Different sprinklers have two types of water pumps: clean water pumps and turbid water pumps. They have different requirements for water sources. Clear water pumps require water to be clarified without any impurities, while turbid water pumps require no hard stones or excessive water in the water. Sand. After the water is sucked in, the next step is watering. When spraying water, the front sprayer of the sprinkler is relatively low and close to the ground, so the spray pressure of the front sprayer is relatively large, which is generally used for flushing the road surface; the position of the rear sprayer is relatively high, and the left and right ends of the rear end are usually each equipped with one Therefore, the watering surface is wider and it is generally suitable for watering during road construction. When using the rear nozzle, the front nozzle should be closed first; when using the adjustable nozzle to spray water, the adjustable nozzle can be adjusted according to the need to adjust the width of the spray. When the width of the sprinkler is larger, the amount of intermediate overlap becomes smaller, so that the density of the sprinkled water becomes more uniform. There will be a sewage pipe on the water tank of the sprinkler. The role of the sewage pipe is as its name implies. The sewage pipe has two ports and the lower port is at the lowest point of the tank for water intake. Every time you use it, you should open the blowdown switch and flush out any debris, floating debris, etc. accumulated in the tank until the water becomes clear. Sprinklers should stop before picking up water or before watering. In addition, lubrication oil should be regularly added to each lubrication point of the transmission assembly during use, and fastening points must be frequently tightened to prevent aging of the sprinkler components and rigidity caused by corrosion. Drinking Water Faucets, Drinking Water Tap, Kitchen Drinking Water Faucet, Stainless Steel Drinking Water Faucet ZHEJIANG KINGSIR VALVE CO., LTD. , https://www.kingsirvalve.com
